New Cold Removal of Electronic Components from PCB

By: PRLog

No more damaging components or circuit boards with the new cold removal process from BEST.

ROLLING MEADOWS, Ill. - Oct. 21, 2022 - PRLog -- Rolling Meadows, ILBEST Inc. is pleased to announce the installation of a high precision milling center the AVX1000M from Air-Vac Engineering.

This milling system allows BEST to remove components using a cold rework process. This process capability replaces the high temperature desoldering process with a high precision milling process design for PCBs. This cold removal technique increases PCB rework yields as underfilled components do not have solder pushed around during the removal process thus causing soldering failures. The cold component removal is also appropriate in cases where the components to be removed are very close to heat-sensitive components or where a hot soldering iron may not be easily squeezed into tight spaces.

The AVX1000M is designed for high end PCB rework. The milling system features precision laser measuring and alignment controls for removing the entire component to within a few thousandths of the PCB surface. The milling center also has vibration control including an integrated vacuum fixture. The machine has a built-in vacuum system to prevent debris from contaminating the PCB during the milling operation.

Dan Patten, BEST general manager stated "With this service capability BEST can now service customers requiring high volume rework of underfilled PCBs. This is going to be beneficial for automotive, consumer and military customers with handheld device using underfill."

About Business Electronics Soldering Technologies (BEST)
BEST is a supplier of PCB rework and repair services and soldering tools in the communications, computer, industrial, automotive, avionic, and military sectors. Headquartered in Rolling Meadows, Illinois BEST is a master IPC-certified solder and wire harness training center certifying students and instructors in IPC-A-620, J-STD-001, IPC-A-610 and IPC 7711/21. Training takes place in Chicago, Minneapolis, Detroit, Cleveland and near Raleigh, NC.

Contact:  Dan Patten, BEST Inc.
info@solder.net
(847)-797-9250

Contact
Dan Patten
***@solder.net

Photos: (Click photo to enlarge)

BEST Inc Logo Best Avx1000m

Read Full Story - New Cold Removal of Electronic Components from PCB | More news from this source

Press release distribution by PRLog

Data & News supplied by www.cloudquote.io
Stock quotes supplied by Barchart
Quotes delayed at least 20 minutes.
By accessing this page, you agree to the following
Privacy Policy and Terms and Conditions.